Specifications

set radio-profile preamble-length
Chapter 12
AP Commands
320
The following commands disable the radios that use radio profile rp1, change the
beacon interval, then reenable the radios:
PROPMT# set radio-profile rp1 mode disable
PROPMT# set radio-profile rp1 beacon-interval 200
PROPMT# set radio-profile rp1 mode enable
The following command enables the WPA IE on AP radios in radio profile rp2:
PROPMT# set radio-profile rp2 wpa-ie enable
success: change accepted.
See Also
l set ap radio mode on page 295
l set ap radio radio-profile on page 296
l show ap config on page 374
l show radio-profile on page 408
set radio-profile preamble-length
Changes the preamble length for which an 802.11b/g AP radio advertises support.
This command does not apply to 802.11a.
Syntax set radio-profile name preamble-length {long | short}
Defaults The default is short.
Access Enabled.
Usage Changing the preamble length value affects only the support advertised by
the radio. Regardless of the preamble length setting (short or long), an 802.11b/g
radio accepts and can generate 802.11b/g frames with either short or long
preambles.
name Radio profile name.
long Advertises support for long preambles.
short Advertises support for short preambles.