Specifications

set radio-profile service-profile
Chapter 12
AP Commands
327
dhcp-restrict disable Does not restrict a client’s
traffic to only DHCP traffic
while the client is being
authenticated and authorized.
idle-client-probing enable Sends a keepalive packet (a
null-data frame) to each client
every 10 seconds.
keep-initial-vlan disable Reassigns the user to a VLAN
after roaming, instead of
leaving the roamed user on the
VLAN assigned by the switch
where the user logged on.
Note: Enabling this option
does not retain the initial
VLAN assignment for a user
in all cases. (For information,
see “set service-profile
keep-initial-vlan” on
page 350.)
long-retry-count 5 Sends a long unicast frame up
to five times without
acknowledgment.
no-broadcast disable Does not reduce wireless
broadcast traffic by sending
unicasts to clients for ARP
requests and DHCP Offers and
Acks instead of forwarding
them as multicasts.
proxy-arp enable Replies on behalf of wireless
clients to ARP requests for
client IP addresses, instead of
forwarding the ARP Requests
as wireless broadcasts.
Table 34. Defaults for Service Profile Parameters
Parameter Default Value
Radio Behavior When
Parameter Set To Default
Value