Specifications

set service-profile auth-psk
Chapter 12
AP Commands
339
Examples The following command sets the fallthru authentication type for SSIDS
managed by the service profile rnd_lab to web-portal:
PROPMT# set service-profile rnd_lab auth-fallthru web-portal
success: change accepted.
See Also
l set web-portal on page 240
l set service-profile web-portal-form on page 366
l show service-profile on page 413
set service-profile auth-psk
Enables pre-shared key (PSK) authentication of Wi-Fi Protected Access (WPA)
clients by UNIVERGE WL Access Points radios in a radio profile, when the
WPA information element (IE) is enabled in the service profile.
Syntax set service-profile name auth-psk {enable | disable}
Defaults When the WPA IE is enabled, PSK authentication of WPA clients is
enabled by default. If the WPA IE is disabled, the auth-psk setting has no effect.
Access Enabled.
Usage This command affects authentication of WPA clients only.
To use PSK authentication, you also must configure a passphrase or key. In
addition, you must enable the WPA IE.
Examples The following command enables PSK authentication for service profile
wpa_clients:
PROPMT# set service-profile wpa_clients auth-psk enable
success: change accepted.
name Service profile name.
enable Enables PSK authentication of WPA clients.
disable Disables PSK authentication of WPA clients.