Specifications

set service-profile static-cos
Chapter 12
AP Commands
360
Syntax set service-profile name ssid-type [clear | crypto]
Defaults The default SSID type is crypto.
Access Enabled.
Examples The following command changes the SSID type for service profile
clear_wlan to clear:
PROPMT# set service-profile clear_wlan ssid-type clear
success: change accepted.
See Also
l set service-profile ssid-name on page 359
l show service-profile on page 413
set service-profile static-cos
Enables or disables static CoS on a service profile. Static CoS assigns the same
CoS level to all traffic on the service profile’s SSID, regardless of 802.1p or
DSCP markings in the packets themselves, and regardless of any ACLs that mark
CoS. This option provides a simple way to configure an SSID for priority traffic
such as VoIP traffic.
When static CoS is enabled, the standard UNIVERGE WL Control System
prioritization mechanism is not used. Instead, the UNIVERGE WL Access Points
sets CoS as follows:
l For traffic from the UNIVERGE WL Access Points to clients, the
UNIVERGE WL Access Points places the traffic into the forwarding queue
that corresponds to the CoS level configured on the service profile. For
example, if the static CoS level is set to 7, the UNIVERGE WL Access Points
radio places client traffic in its Voice queue.
name Service profile name.
clear Wireless traffic for the service profile’s SSID is not
encrypted.
crypto Wireless traffic for the service profile’s SSID is encrypted.