Specifications

set system idle-timeout
Chapter 4
System Services Commands
35
Defaults The factory default country code is None.
Access Enabled.
Usage You must set the system county code to a valid value before using any
set ap commands to configure a UNIVERGE WL Access Points.
Examples To set the country code to Canada, type the following command:
Controller#set system country code CA
success: change accepted.
See Also show config on page 600
set system idle-timeout
Specifies the maximum number of seconds a CLI management session with the
UNIVERGE WL Controller can remain idle before UNIVERGE WL Control
System terminates the session.
Syntax set system idle-timeout seconds
Defaults 3600 seconds (one hour).
Note. Under no circumstances should you specify a country code that does
not match the country of operation. If the country of operation is not listed in
Table 1, this might be because the country has not yet approved the use of this
equipment. In this case, contact your local supplier before installing the
equipment.
seconds Number of seconds a CLI management session can remain
idle before UNIVERGE WL Control System terminates the
session. You can specify from 0 to 86400 seconds (one
day). If you specify 0, the idle timeout is disabled.
The timeout interval is in 30-second increments. For
example, the interval can be 0, or 30 seconds, or 60 seconds,
or 90 seconds, and so on. If you enter an interval that is not
divisible by 30, the CLI rounds up to the next 30-second
increment. For example, if you enter 31, the CLI rounds up
to 60.