Specifications

show ap status
Chapter 12
AP Commands
391
Defaults None.
Access Enabled.
Examples The following command displays the status of an AP:
PROPMT# show ap status 7
AP: 7, AP model: WL1500-AP, manufacturer NEC Infrontia, name: AP07
====================================================
State: operational (not encrypt)
CPU info: Atheros:MIPS32 speed=220000000 Hz version=AR5312, ram=16777216
s/n=G8TZUB0028 hw_rev=B
Uptime: 503 hours, 51 minutes, 5 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 11(Auto) operational power: 1
bssid1: 00:60:b9:11:57:c0, ssid: public
bssid2: 00:60:b9:11:57:c2, ssid: employee-net
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
Radio 2 type: 802.11a, state: configure succeed [Disabled](Sweep mode)
operational channel: 44(Auto) operational power: 1
bssid1: 00:60:b9:11:57:c1, ssid: mycorp-tkip
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
The following command uses the terse option to display brief information for
UNIVERGE WL Access Points:
PROPMT# show ap status terse
Total number of entries: 120
Operational: 1, Image Downloading: 0, Unknown: 119, Other: 0
Flags: o = operational, b = booting, d = image downloading
c = configuring, f = configuration failed
a = auto AP, m = mesh AP, p = mesh portal
i = insecure, e = encrypted, u = unencrypt
AP Flag IP Address Model MAC Address Radio1 Radio2 Uptime
-- ---- ------------- --------- ----------------- ------ ------ --------
7 o-u 10.8.255.11 WL1500-AP 00:60:b9:11:da:82 D11/1 D44/1 21d00h
Table 40 and Table 41 describe the fields in these displays.