Specifications

show ap status
Chapter 12
AP Commands
394
CPU info Specifications and identification of the CPU.
Uptime Amount of time since the AP booted using this link.
Radio 1 type
Radio 2 type
802.11 type and configuration state of the radio.
•The configure succeed state indicates that the AP
has received configuration parameters for the
radio and the radio is ready to accept client
connections.
• 802.11b protect indicates that the 802.11b/g radio
is sending messages to 802.11b devices, while
sending 802.11g traffic at higher data rates, to
inform the 802.11b devices about the 802.11g
traffic and reserve bandwidth for the traffic.
Protection mode remains in effect until 60
seconds after the last 802.11b traffic is detected
by the 802.11b/g radio.
• Sweep Mode indicates that a disabled radio is
nonetheless participating in rogue detection
scans. Even though this message appears only for
disabled radios, all radios, enabled or disabled,
participate in rogue detection.
• Countermeasures Enabled indicates that the radio
is sending countermeasures packets to combat a
rogue.
• Radar Scan indicates that the radio is performing
the initial channel availability check for Dynamic
Frequency Selection (DFS). This state lasts
during the first 60 seconds an 802.11a radio is on
a new channel, during which time the radio does
not transmit. If the radio does not detect any radar
on the channel, the radio starts using the channel
for data. If the radio does detect radar, the flag
changes to Radar Detected. (See below).
Table 40. Output for show ap status
Field Description