Specifications

show ap status
Chapter 12
AP Commands
395
Radio 1 type
Radio 2 type
(cont.)
• Radar Detected indicates that DFS has detected
radar on the channel. When this occurs, the
UNIVERGE WL Access Points stops
transmitting on the channel for 30 minutes. If RF
Auto-Tuning is enabled for channel assignment,
the radio selects another channel and performs the
initial channel availability check on the new
channel, during which time the flag changes back
to Radar Scan.
Note: Radar Scan and Radar Detected apply only to
802.11a radios, for country codes that use DFS.
• The following information appears for external
antennas:
• External antenna detected, configured as
antenna-model—Indicates that an external
antenna has been detected, and lists the
antenna model configured on the radio.
(UNIVERGE WL Control System does not
detect the specific model.)
• External antenna detected, not configured—
Indicates that an external antenna was detected
but no external antenna is configured on the
radio.
• External antenna not detected, configured as
antenna-model—Indicates that an external
antenna is configured on the radio but no
external antenna was detected.
operational channel The channel on which the radio is currently
operating.
Note: If the channel number is followed by (Auto),
the value was set by RF Auto-Tuning.
operational power The power level at which the radio is currently
operating.
Note: If the power setting is followed by (Auto), the
value was set by RF Auto-Tuning.
Table 40. Output for show ap status
Field Description