Specifications

show auto-tune neighbors
Chapter 12
AP Commands
399
l set radio-profile auto-tune channel-config on page 301
l set radio-profile auto-tune channel-holddown on page 303
l set radio-profile auto-tune channel-interval on page 304
l set radio-profile auto-tune power-config on page 305
l set radio-profile auto-tune power-interval on page 306
l show auto-tune neighbors on page 399
l show radio-profile on page 408
show auto-tune neighbors
Displays the other AP radios and third-party 802.11 radios that an AP radio can
hear.
Syntax show auto-tune neighbors
[ap ap-number [radio {1 | 2| all}]]
Defaults None.
Access Enabled.
Usage For simplicity, this command displays a single entry for each AP radio,
even if the radio is supporting multiple BSSIDs. However, BSSIDs for third-party
802.11 radios are listed separately, even if a radio is supporting more than one
BSSID.
ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
radio 1 Shows neighbor information for radio 1.
radio 2 Shows neighbor information for radio 2. (This option does
not apply to single-radio models.)
radio all Shows neighbor information for both radios.