Specifications

show ap boot-configuration
Chapter 12
AP Commands
401
l show auto-tune attributes on page 397
l show radio-profile on page 408
show ap boot-configuration
Displays information about the static IP address configuration (if any) on a
UNIVERGE WL Access Points.
Syntax show ap boot-configuration ap-number
Defaults None.
Access Enabled.
Examples The following command displays static IP configuration information
for UNIVERGE WL Access Points 1:
PROPMT# show ap boot-configuration 1
Static Boot Configuration
AP: 7
IP Address: Disabled
VLAN Tag: Disabled
Switch: Disabled
Mesh: Disabled
IP Address:
Netmask:
Gateway:
VLAN Tag:
Switch IP:
Switch Name:
DNS IP:
Mesh SSID:
Mesh PSK:
Table 44 describes the fields in this display.
ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.