Specifications

show ap connection
Chapter 12
AP Commands
403
show ap connection
Displays the system IP address of the UNIVERGE WL Controller that booted a
UNIVERGE WL Access Points.
Syntax show ap connection [ap-number | serial-id serial-ID]
Defaults None.
Access Enabled.
Usage The serial-id parameter displays the active connection for the specified
UNIVERGE WL Access Points even if that UNIVERGE WL Access Points is not
configured on this UNIVERGE WL Controller. If you instead use the command
with the ap-number parameter or without a parameter, connection information is
displayed only for UNIVERGE WL Access Points that are configured on this
UNIVERGE WL Controller.
This command provides information only if the UNIVERGE WL Access Points is
configured on the UNIVERGE WL Controller where you use the command. The
UNIVERGE WL Controller does not need to be the one that booted the
UNIVERGE WL Access Points, but it must have the UNIVERGE WL Access
Points in its configuration. Also, the UNIVERGE WL Controller that booted the
UNIVERGE WL Access Points must be in the same Mobility Domain as the
UNIVERGE WL Controller where you use the command.
Mesh SSID The WLAN mesh services SSID this UNIVERGE
WL Access Points is configured to use (if any)
Mesh PSK The preshared key (PSK) the UNIVERGE WL
Access Points uses for authentication with a Mesh
Portal AP (if any).
ap-number Index value that identifies the UNIVERGE WL
Access Points on the UNIVERGE WL Controller.
serial-id serial-ID AP serial ID.
Table 44. Output for show ap boot-configuration
Field Description