Specifications

set system location
Chapter 4
System Services Commands
37
See Also
l clear system on page 23
l set interface on page 111
l show system on page 40
set system location
Stores location information for the UNIVERGE WL Controller.
Syntax set system location string
Defaults None.
Access Enabled.
Usage You cannot include spaces in the system location string. To view the
system location string, type the show system command.
Examples To store the location of the UNIVERGE WL Controller in the
UNIVERGE WL Controller’s configuration, type the following command:
PROMPT# set system location first-floor-bldg3
success: change accepted.
See Also
l clear system on page 23
l set system contact on page 32
l set system name on page 38
l show system on page 40
string Alphanumeric string up to 256 characters long. (blank spaces are
available to input.)