Specifications

show ap global
Chapter 12
AP Commands
406
To show information only for UNIVERGE WL Access Points that have active
connections, use the show ap connection command.
Examples The following command displays connection information for all the
UNIVERGE WL Access Points configured on a UNIVERGE WL Controller:
PROPMT# show ap global
AP Serial Id Switch IP Address
--- ----------- --------------------
3 G8TZUB0053 192.168.10.10 HIGH
4 G8TZUB0253 192.168.10.20 LOW
Table 46 describes the fields in this display.
Table 46. Output for show ap global
Field Description
AP ID you assigned to the UNIVERGE WL Access
Point.
Note: AP numbers are listed only for UNIVERGE
WL Access Points configured on this UNIVERGE
WL Controller. If the field contains a hyphen ( - ),
the UNIVERGE WL Access Point configuration
displayed in the row of output is on another
UNIVERGE WL Controller.
Serial Id Serial ID of the UNIVERGE WL Access Points.
Switch IP Address System IP address of the UNIVERGE WL Controller
on which the UNIVERGE WL Access Points is
configured. A separate row of output is displayed for
each UNIVERGE WL Controller on which the
UNIVERGE WL Access Points is configured.
Bias Bias of the UNIVERGE WL Controller for the
UNIVERGE WL Access Points:
•High
•Low