Specifications

show radio-profile
Chapter 12
AP Commands
411
Tune Power Interval Interval, in seconds, at which RF Auto-Tuning
decides whether to change the power level on radios
in a radio profile. At the end of each interval,
UNIVERGE WL Control System processes the
results of the RF scans performed during the
previous interval, and changes radio power levels if
needed.
Power ramp interval Number of seconds a radio waits before increasing or
decreasing its power by 1 dBm in response to a
power change from RF Auto-Tuning. After each
power ramp interval, the radio increases or decreases
the power by another 1 dB until the radio reaches the
power level selected by RF Auto-Tuning.
Channel Holddown Minimum number of seconds a radio in a radio
profile must remain at its current channel assignment
before RF Auto-Tuning can change the channel.
Countermeasures Indicates whether countermeasures are enabled.
Active-Scan Indicates whether the active-scan mode of RF
detection is enabled.
RFID enabled Indicates whether AeroScout tag support is enabled.
WMM Powersave Indicates whether U-APSD support is enabled.
Table 48. Output for show radio-profile
Field Description