Specifications

set system name
Chapter 4
System Services Commands
38
set system name
Changes the name of the UNIVERGE WL Controller from the default system
name and also provides content for the CLI prompt, if you do not specify a
prompt.
Syntax set system name string
Defaults By default, the system name and command prompt have the same
value. The factory default for both is UNIVERGE-mm_nnnnnn, where mm is the
model number and nnnnnn is the last 6 digits of the 12-digit system MAC address.
Access Enabled.
Usage Entering set system name with no string resets the system name to the
factory default.
To view the system name string, type the show system command.
Examples The following example sets the system name to a name that identifies
the UNIVERGE WL Controller:
PROMPT# set system name WL-bldg3
success: change accepted.
WL-bldg3#
See Also
l clear system on page 23
l set prompt on page 31
l set system contact on page 32
l set system location on page 37
l show system on page 40
string Alphanumeric string up to 99 characters long. (blank spaces are
available to input.) UNIVERGE WLMS requires unique
UNIVERGE WL Controller names.