Specifications
set igmp lmqi
Chapter 13
IGMP Snooping Commands
429
success: change accepted.
See Also
show igmp on page 438
set igmp lmqi
Changes the IGMP last member query interval timer on one VLAN or all VLANs
on a UNIVERGE WL Controller.
Syntax
set igmp lmqi tenth-seconds [vlan vlan-id]
Defaults
The default last member query interval is 10 tenths of a second
(1 second).
Access
Enabled.
Examples
The following command changes the last member query interval on
VLAN orange to 5 tenths of a second:
PROMT# set igmp lmqi 5 vlan orange
success: change accepted.
See Also
l set igmp oqi on page 432
l set igmp qi on page 433
l set igmp mrouter on page 430
lmqi tenth-seconds Amount of time (in tenths of a second) that the
UNIVERGE WL Controller waits for a response to a
group-specific query after receiving a leave message
for that group, before removing the receiver that sent
the leave message from the list of receivers for the
group. If there are no more receivers for the group, the
UNIVERGE WL Controller also sends a leave
message for the group to multicast routers. You can
specify a value from 1 through 65,535.
vlan
vlan-id VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.