Specifications

set igmp qi
Chapter 13
IGMP Snooping Commands
434
Syntax set igmp qi seconds [vlan vlan-id]
Defaults The default query interval is 125 seconds.
Access Enabled.
Usage The query interval is applicable only when the UNIVERGE WL
Controller is querier for the subnet. For the UNIVERGE WL Controller to
become the querier, the pseudo-querier feature must be enabled on the
UNIVERGE WL Controller and the UNIVERGE WL Controller must have the
lowest IP address among all the devices eligible to become a querier. To enable
the pseudo-querier feature, use the set igmp querier command.
Examples The following command changes the query interval on VLAN orange
to 100 seconds:
PROMT# set igmp qi 100 vlan orange
success: change accepted.
See Also
l set igmp lmqi on page 429
l set igmp oqi on page 432
l set igmp qri on page 435
l set igmp querier on page 436
l set igmp mrouter on page 430
l set igmp rv on page 437
qi
seconds Number of seconds that elapse between general queries sent
by the UNIVERGE WL Controller when the UNIVERGE
WL Controller is the querier for the subnet. You can specify
a value from 1 through 65,535.
vlan
vlan-id VLAN name or number. If you do not specify a VLAN, the
timer change applies to all VLANs.