Specifications

set igmp qri
Chapter 13
IGMP Snooping Commands
435
set igmp qri
Changes the IGMP query response interval timer on one VLAN or all VLANs on
a UNIVERGE WL Controller.
Syntax set igmp qri tenth-seconds [vlan vlan-id]
Defaults The default query response interval is 100 tenths of a second
(10 seconds).
Access Enabled.
Usage The query response interval is applicable only when the UNIVERGE WL
Controller is querier for the subnet. For the UNIVERGE WL Controller to
become the querier, the pseudo-querier feature must be enabled on the
UNIVERGE WL Controller and the UNIVERGE WL Controller must have the
lowest IP address among all the devices eligible to become a querier. To enable
the pseudo-querier feature, use set igmp querier.
Examples The following command changes the query response interval on
VLAN orange to 50 tenths of a second (5 seconds):
PROMT# set igmp qri 50 vlan orange
success: change accepted.
See Also
l set igmp lmqi on page 429
l set igmp oqi on page 432
l set igmp qi on page 433
l set igmp querier on page 436
l set igmp rv on page 437
qri tenth-seconds Amount of time (in tenths of a second) that the
UNIVERGE WL Controller waits for a receiver to
respond to a group-specific query message before
removing the receiver from the receiver list for the
group. You can specify a value from 1 through 65,535.
vlan
vlan-id VLAN name or number. If you do not specify a VLAN,
the timer change applies to all VLANs.