Specifications

RADIUS and Server Groups Commands
499
16
RADIUS and Server Groups
Commands
Use RADIUS commands to set up communication between a UNIVERGE WL
Controller and groups of up to four RADIUS servers for remote authentication,
authorization, and accounting (AAA) of administrators and network users. This
chapter presents RADIUS commands alphabetically. Use the following table to
locate commands in this chapter based on their uses.
(For information about RADIUS attributes, see the RADIUS appendix in the
Configuration Guide.)
RADIUS Client set radius client system-ip on page 506
clear radius client system-ip on page 501
RADIUS Servers set radius on page 503
set radius server on page 506
clear radius on page 500
clear radius server on page 502
Server Groups set server group on page 509
set server group load-balance on page 510
clear server group on page 502