Specifications

set server group
Chapter 16
RADIUS and Server Groups Commands
509
l set radius on page 503
l set server group on page 509
l show aaa on page 240
set server group
Configures a group of one to four RADIUS servers.
Syntax set server group group-name members server-name1 [server-name2]
[server-name3] [server-name4]
Defaults None.
Access Enabled.
Usage You must assign all group members simultaneously, as shown in the
example. To enable load balancing, use set server group load-balance enable.
Do not use the same name for a RADIUS server and a RADIUS server group.
Examples To set server group shorebirds with members heron, egret, and
sandpiper, type the following command:
Controller# set server group shorebirds members heron egret sandpiper
success: change accepted.
See Also
l clear server group on page 502
l set server group load-balance on page 510
group-name Server group name of up to 32 characters, with no spaces or
tabs.
members
server-name1
server-name2
server-name3
server-name4
The names of one or more configured RADIUS servers.
You can enter up to four server names.