Specifications

clear dot1x max-req
Chapter 17
802.1X Management Commands
515
clear dot1x max-req
Resets to the default setting the number of Extensible Authentication Protocol
(EAP) requests that the UNIVERGE WL Controller retransmits to a supplicant
(client).
Syntax clear dot1x max-req
Defaults The default number is 20.
Access Enabled.
Examples To reset the number of 802.1X requests the UNIVERGE WL
Controller can send to the default setting, type the following command:
PROMPT# clear dot1x max-req
success: change accepted.
See Also
l set dot1x max-req on page 520
l show dot1x on page 526
clear dot1x quiet-period
Resets the quiet period after a failed authentication to the default setting.
Syntax clear dot1x quiet-period
Defaults The default is 60 seconds.
Access Enabled.
Examples Type the following command to reset the 802.1X quiet period to the
default:
PROMPT# clear dot1x quiet-period
success: change accepted.
See Also
l set dot1x quiet-period on page 520
l show dot1x on page 526