Specifications

clear dot1x tx-period
Chapter 17
802.1X Management Commands
518
clear dot1x tx-period
Resets to the default setting the number of seconds that must elapse before the
UNIVERGE WL Controller retransmits an EAP over LAN (EAPoL) packet.
Syntax clear dot1x tx-period
Defaults The default is 5 seconds.
Access Enabled.
Examples Type the following command to reset the EAPoL retransmission time:
PROMPT# clear dot1x tx-period
success: change accepted.
See Also
l set dot1x tx-period on page 524
l show dot1x on page 526
set dot1x bonded-period
Changes the Bonded Auth™ (bonded authentication) period. The Bonded Auth
period is the number of seconds UNIVERGE WL Control System allows a
Bonded Auth user to reauthenticate.
Syntax set dot1x bonded-period seconds
Defaults The default bonded period is 0 seconds, which disables the feature.
Access Enabled.
seconds Number of seconds UNIVERGE WL Control System
retains session information for an authenticated machine
while waiting for a client to (re)authenticate on the same
machine. You can change the bonded authentication period
to a value from 1 to 300 seconds.