Specifications

set dot1x timeout auth-server
Chapter 17
802.1X Management Commands
523
Access Enabled.
Usage You also can use the RADIUS session-timeout attribute to set the
reauthentication timeout for a specific client. In this case, UNIVERGE WL
Control System uses the timeout that has the lower value. If the session-timeout is
set to fewer seconds than the global reauthentication timeout, UNIVERGE WL
Control System uses the session-timeout for the client. However, if the global
reauthentication timeout is shorter than the session-timeout, UNIVERGE WL
Control System uses the global timeout instead.
Examples Type the following command to set the number of seconds to 100
before reauthentication is attempted:
PROMPT# set dot1x reauth-period 100
success: dot1x auth-server timeout set to 100.
See Also
l clear dot1x reauth-period on page 516
l show dot1x on page 526
set dot1x timeout auth-server
Sets the number of seconds that must elapse before the UNIVERGE WL
Controller times out a request to a RADIUS authentication server.
Syntax set dot1x timeout auth-server seconds
Defaults The default is 30 seconds.
Access Enabled.
Examples Type the following command to set the authentication server timeout
to 60 seconds:
PROMPT# set dot1x timeout auth-server 60
success: dot1x auth-server timeout set to 60.
See Also
l clear dot1x timeout auth-server on page 517
l show dot1x on page 526
seconds Specify a value between 1 and 65,535.