Specifications

monitor port counters
Chapter 5
Port Commands
49
For error reporting, the cyclic redundancy check (CRC) errors include
misalignment errors. Jumbo packets with valid CRCs are not counted. A short
packet can be reported as a short packet, a CRC error, or an overrun. In some
circumstances, the transmitted octets counter might increment a small amount for
a port with nothing attached.
Examples The following command starts the port statistics monitor beginning
with octet statistics (the default):
PROMPT# monitor port counters
As soon as you press Enter, UNIVERGE WL Control System clears the window
and displays statistics at the top of the window.
Port Status Rx Octets Tx Octets
=================================================================
1 Up 27965420 34886544
...
To cycle the display to the next set of statistics, press the Spacebar. In this
example, packet statistics are displayed next:
Port Status Rx Unicast Rx NonUnicast Tx Unicast Tx NonUnicast
====================================================================
1 Up 54620 62144 68318 62556
...
Table 4 describes the port statistics displayed by each statistics option. The Port
and Status fields are displayed for each option.
Esc Exits the monitor. UNIVERGE WL Control System
stops displaying the statistics and displays a new
command prompt.
c Clears the statistics counters for the currently
displayed statistics type. The counters begin
incrementing again.
Table 3. Key Controls for Monitor Port Counters Display
Key Effect on Monitor Display