Specifications

set rfdetect ssid-list
Chapter 19
RF Detection Commands
557
Examples The following command enables UNIVERGE WL Access Points
signatures on a UNIVERGE WL Controller:
Controller# set rfdetect signature enable
success: signature is now enabled.
set rfdetect ssid-list
Adds an SSID to the permitted SSID list.The permitted SSID list specifies the
SSIDs that are allowed on the network. If UNIVERGE WL Control System
detects packets for an SSID that is not on the list, the AP that sent the packets is
classified as a rogue. UNIVERGE WL Control System issues countermeasures
against the rogue if they are enabled.
Syntax set rfdetect ssid-list ssid-name
Defaults The permitted SSID list is empty by default and all SSIDs are allowed.
However, after you add an entry to the list, UNIVERGE WL Control System
allows traffic only for the SSIDs that are on the list.
Access Enabled.
Usage The permitted SSID list applies only to the UNIVERGE WL Controller
on which the list is configured. UNIVERGE WL Controllers do not share
permitted SSID lists.
If you add a device that UNIVERGE WL Control System has classified as a rogue
to the permitted SSID list, but not to the ignore list, UNIVERGE WL Control
System can still classify the device as a rogue. Adding an entry to the permitted
SSID list merely indicates that the device is using an allowed SSID. However, to
cause UNIVERGE WL Control System to stop classifying the device as a rogue,
you must add the device’s MAC address to the ignore list.
Examples The following command adds SSID mycorp to the list of permitted
SSIDs:
PROPMT# set rfdetect ssid-list mycorp
success: ssid mycorp is now in ssid-list.
ssid-name SSID name you want to add to the permitted SSID list.