Specifications

set rfdetect vendor-list
Chapter 19
RF Detection Commands
558
See Also
l clear rfdetect ssid-list on page 550
l show rfdetect ssid-list on page 573
set rfdetect vendor-list
Adds an entry to the permitted vendor list. The permitted vendor list specifies the
third-party AP or client vendors that are allowed on the network. UNIVERGE
WL Control System does not list a device as a rogue or interfering device if the
device’s OUI is in the permitted vendor list.
Syntax set rfdetect vendor-list {client | ap} mac-addr
Defaults The permitted vendor list is empty by default and all vendors are
allowed. However, after you add an entry to the list, UNIVERGE WL Control
System allows only the devices whose OUIs are on the list.
Access Enabled.
Usage The permitted vendor list applies only to the UNIVERGE WL Controller
on which the list is configured. UNIVERGE WL Controllers do not share
permitted vendor lists.
If you add a device that UNIVERGE WL Control System has classified as a rogue
to the permitted vendor list, but not to the ignore list, UNIVERGE WL Control
System can still classify the device as a rogue. Adding an entry to the permitted
vendor list merely indicates that the device is from an allowed vendor. However,
to cause UNIVERGE WL Control System to stop classifying the device as a
rogue, you must add the device’s MAC address to the ignore list.
Examples The following command adds an entry for clients whose MAC
addresses start with aa:bb:cc:
PROPMT# set rfdetect vendor-list client aa:bb:cc:00:00:00
success: MAC aa:bb:cc:00:00:00 is now in client vendor-list.
client | ap Specifies whether the entry is for an AP brand or a client
brand.
mac-addr | all Organizationally Unique Identifier (OUI) to remove.