Specifications

show rfdetect countermeasures
Chapter 19
RF Detection Commands
563
show rfdetect countermeasures
Displays the current status of countermeasures against rogues in the Mobility
Domain.
Syntax show rfdetect countermeasures
Defaults None.
Access Enabled.
Usage This command is valid only on the seed UNIVERGE WL Controller of
the Mobility Domain.
Examples The following example displays countermeasures status for the
Mobility Domain:
Typ Classification of the rogue device:
• rogue—Wireless device that is on the network but
is not supposed to be on the network.
• intfr—Wireless device that is not part of your
network and is not a rogue, but might be causing
RF interference with UNIVERGE WL Access
Points radios.
• known—Device that is a legitimate member of the
network.
Dst MAC addressed to which the last 802.11 packet
detected from the client was addressed.
Last Rogue Status Check Number of seconds since the UNIVERGE WL
Controller looked on the air for the AP with which the
rogue client is associated. The UNIVERGE WL
Controller looks for the client’s AP by sending a
packet from the wired side of the network addressed
to the client, and watching the air for a wireless
packet containing the client’s MAC address.
Table 69. show rfdetect clients mac Output
Field Description