Specifications

reset port
Chapter 5
Port Commands
53
See Also show port counters on page 62
reset port
Resets a port by toggling its link state and Power over Ethernet state.
Syntax reset port port-list
Defaults None.
Access Enabled.
Usage The reset command disables the port link for at least 1 second, then
reenables them. This behavior is useful for forcing an AP that is connected to two
UNIVERGE WL Controller to reboot over the link to the other UNIVERGE WL
Controller.
transmit-etherstats Tx 64 Number of packets transmitted that were
64 bytes long.
Tx 127 Number of packets transmitted that were
from 65 through 127 bytes long.
Tx 255 Number of packets transmitted that were
from 128 through 255 bytes long.
Tx 511 Number of packets transmitted that were
from 256 through 511 bytes long.
Tx 1023 Number of packets transmitted that were
from 512 through 1023 bytes long.
Tx 1518 Number of packets transmitted that were
from 1024 through 1518 bytes long.
port-list List of physical ports. UNIVERGE WL Control System
resets all the specified ports.
Table 4. Output for monitor port counters
Statistics Option Field Description