Specifications

show rfdetect data
Chapter 19
RF Detection Commands
566
show rfdetect data
Displays information about the APs detected by a UNIVERGE WL Controller.
Syntax show rfdetect data
Defaults None.
Access Enabled.
Usage You can enter this command on any UNIVERGE WL Controller in the
Mobility Domain. The output applies only to the UNIVERGE WL Controller on
which you enter the command. To display all devices that a specific UNIVERGE
WL Access Points radio has detected, even if the radio is managed by another
UNIVERGE WL Controller, use the show rfdetect visible command.
To display rogue information for the entire Mobility Domain, use the show
rfdetect mobility-domain command on the seed UNIVERGE WL Controller.
Only one MAC address is listed for each UNIVERGE WL Access Points radio,
even if the radio is beaconing multiple SSIDs.
Examples The following command shows the devices detected by this
UNIVERGE WL Controller during the most recent RF detection scan:
PROPMT# show rfdetect data
Total number of entries: 197
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
BSSID Vendor Type Port/Radio/Ch Flags RSSI Age SSID
----------------- ------- ----- ------------- ------ ---- --- -----------------
00:07:50:d5:cc:91 Cisco intfr 3/1/6 i----w -61 6 r27-cisco1200-2
00:07:50:d5:dc:78 Cisco intfr 3/1/6 i----w -82 6 r116-cisco1200-2
00:09:b7:7b:8a:54 Cisco intfr 3/1/2 i----- -57 6
00:0a:5e:4b:4a:c0 3Com intfr 3/1/11 i----- -57 6 public
00:0a:5e:4b:4a:c2 3Com intfr 3/1/11 i-t1-- -86 6 wlan
00:0a:5e:4b:4a:c4 3Com intfr 3/1/11 ic---- -85 6 ccmp
00:0a:5e:4b:4a:c6 3Com intfr 3/1/11 i-t--- -85 6 tkip
00:0a:5e:4b:4a:c8 3Com intfr 3/1/11 i----w -83 6 -voip
00:0a:5e:4b:4a:ca 3Com intfr 3/1/11 i----- -85 6 webaaa
...
Table 71 describes the fields in this display.