Specifications

clear boot config
Chapter 20
File Management Commands
580
Syntax clear boot backup-configuration
Defaults None.
Access Enabled.
Examples The following command clears the name specified as the backup
configuration file from the configuration of the UNIVERGE WL Controller:
PROMPT# clear boot backup-configuration
success: Backup boot config filename was cleared.
See Also
l set boot backup-configuration on page 595
l show boot on page 597
clear boot config
Resets to the factory default the configuration that UNIVERGE WL Control
System loads during a reboot.
Syntax clear boot config
Defaults None.
Access Enabled.
Examples The following commands back up the configuration file on a
UNIVERGE WL Controller, reset the UNIVERGE WL Controller to its factory
default configuration, and reboot the UNIVERGE WL Controller:
PROMPT# copy configuration tftp://10.1.1.1/backupcfg
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
PROMPT# clear boot config
success: Reset boot config to factory defaults.
PROMPT# reset system force
See Also
l reset system on page 591
l show config on page 600