Specifications

set boot backup-configuration
Chapter 20
File Management Commands
595
Defaults By default, UNIVERGE WL Control System saves the running
configuration as the configuration filename used during the last reboot.
Access Enabled.
Usage If you do not specify a filename, UNIVERGE WL Control System
replaces the configuration file loaded during the most recent reboot. To display
the filename of the configuration file UNIVERGE WL Control System loaded
during the most recent reboot, use the show boot command.
The command completely replaces the specified configuration file with the
running configuration.
Examples The following command saves the running configuration to the
configuration file loaded during the most recent reboot. In this example, the
filename used during the most recent reboot is configuration.
PROMPT# save config
success: configuration saved to configuration.
The following command saves the running configuration to a file named
testconfig1:
PROMPT# save config testconfig1
success: configuration saved to testconfig1.
See Also
l load config on page 587
l show boot on page 597
l show config on page 600
set boot backup-configuration
Specifies the name of a backup configuration file to be used in the event that
UNIVERGE WL Control System cannot read the UNIVERGE WL Controllers
configuration file at boot time.