Manualshelf

Specifications

ManualsBrandsSimplicity ManualsSewing MachineSA2200
51525354555657585960
set port duplex
Chapter 5
Port Commands
56
Defaults
All ports are enabled.
Access
Enabled.
Usage
A port that is administratively disabled cannot send or receive packets.
This command does not affect the link state of the port.
Examples
The following command disables port 1:
PROMPT# set port disable 1
success: set "disable" on port 1
The fol1owing command reenables the port:
PROMPT# set port enable 1
success: set "enable" on port 1
See Also
reset port on page 53
set port duplex
Change the duplex mode of a Ethernet port.
Syntax
set port duplex portlist {full|half}
Defaults
All ports are set to full-duplex.
Access
Enabled.
disable Disables the specified ports.
port-list List of physical ports. UNIVERGE WL Control System
disables or reenables all the specified ports.
port-list List of physical ports. UNIVERGE WL Control System sets
the port duplex mode on all the specified ports.
full Set the duplex mode of a Ethernet port to full-duplex.
half Set the duplex mode of a Ethernet port to half-duplex.