Specifications

set boot configuration-file
Chapter 20
File Management Commands
596
Syntax set boot backup-configuration filename
Defaults By default, there is no backup configuration file.
Access Enabled.
Examples The following command specifies a file called backup.cfg as the
backup configuration file on the UNIVERGE WL Controller:
PROMPT# set boot backup-configuration backup.cfg
success: backup boot config filename set.
See Also
l clear boot backup-configuration on page 579
l show boot on page 597
set boot configuration-file
Changes the configuration file to load after rebooting.
Syntax set boot configuration-file filename
Defaults The default configuration filename is configuration.
Access Enabled.
Usage The file must be located in the UNIVERGE WL Controllers nonvolatile
storage.
filename Name of the file to use as a backup configuration file if
UNIVERGE WL Control System cannot read the
UNIVERGE WL Controllers configuration file.
filename Filename. Specify between 1 and 128 alphanumeric
characters, with no spaces.
To load the file from a subdirectory, specify the
subdirectory name, followed by a forward slash, in front of
the filename. For example: backup_configs/config_c.