Specifications

set boot partition

Chapter 20

File Management Commands

597

Examples

The following command sets the boot configuration file to testconfig1:

PROMPT# set boot configuration-file testconfig1

success: boot config set.

set boot partition

Specifies the boot partition in which to look for the system image file following

the next system reset, software reload, or power cycle.

Syntax

set boot partition {boot0 | boot1}

Defaults

By default, a UNIVERGE WL Controller uses the same boot partition

for the next software reload that was used to boot the currently running image.

Access

Enabled.

Usage

To determine the boot partition that was used to load the currently running

software image, use the dir command.

Examples

The following command sets the boot partition for the next software

reload to partition 1:

PROMPT# set boot partition boot1

success: Boot partition set to boot1:SR060200.003 (6.0.2.0.003).