Specifications

show version
Chapter 20
File Management Commands
602
Defaults None.
Access Enabled.
Usage If you do not use one of the optional parameters, configuration commands
that set nondefault values are displayed for all configuration areas. If you specify
an area, commands are displayed for that area only. If you use the all option, the
display also includes commands for configuration items that are set to their
default values.
Examples The following command shows configuration information for VLANs:
PROMPT# show config area vlan
# Configuration nvgen'd at 2007-2-08 19:10:33
# Image 6.0.2.0.003
# Model SCA-WL10
# Last change occurred at 2007-2-08 19:02:15
set vlan 1 port 1
See Also
l load config on page 587
l save config on page 594
show version
Displays software and hardware version information for a UNIVERGE WL
Controller and, optionally, for any attached UNIVERGE WL Access Points.
Syntax show version [details]
Defaults None
Access All.
details Includes additional software build information and
information about the UNIVERGE WL Access Points
configured on the UNIVERGE WL Controller.