Specifications

Snoop Commands
613
22
Snoop Commands
Use snoop commands to monitor wireless traffic, by using a UNIVERGE WL
Access Point as a sniffing device. The UNIVERGE WL Access Points copies the
sniffed 802.11 packets and sends the copies to an observer, typically a protocol
analyzer such as Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring station, see
the “Remotely Monitoring Traffic” section in the “Troubleshooting a
UNIVERGE WL Controller chapter of the Configuration Guide.)
This chapter presents snoop commands alphabetically. Use the following table to
locate commands in this chapter based on their use.
Remote monitoring
(snooping)
set snoop on page 616
show snoop info on page 621
clear snoop on page 614
set snoop map on page 618
show snoop map on page 621
show snoop on page 620
clear snoop map on page 614
set snoop mode on page 619
show snoop stats on page 622