Specifications

set snoop map
Chapter 22
Snoop Commands
618
The following command configures a snoop filter named snoop2 that matches on
all data traffic between the device with MAC address aa:bb:cc:dd:ee:ff and the
device with MAC address 11:22:33:44:55:66, and copies the traffic to the device
that has IP address 10.10.30.3:
PROPMT# set snoop snoop2 frame-type eq data mac-pair aa:bb:cc:dd:ee:ff
11:22:33:44:55:66 observer 10.10.30.3 snap-length 100
See Also
l clear snoop on page 614
l set snoop map on page 618
l set snoop mode on page 619
l show snoop info on page 621
l show snoop stats on page 622
set snoop map
Maps a snoop filter to a radio on a UNIVERGE WL Access Points. A snoop filter
does take effect until you map it to a radio and enable the filter.
Examples set snoop map filter-name ap ap-num radio {1 | 2}
Defaults Snoop filters are unmapped by default.
Access Enabled.
filter-name Name of the snoop filter.
ap ap-num Number of a UNIVERGE WL Access Points to which to
map the snoop filter.
radio 1 Radio 1 of the UNIVERGE WL Access Points.
radio 2 Radio 2 of the UNIVERGE WL Access Points. (This option
does not apply to single-radio models.)