Specifications

set snoop mode
Chapter 22
Snoop Commands
619
Usage You can map the same filter to more than one radio. You can map up to
eight filters to the same radio. If more than one filter has the same observer, the
UNIVERGE WL Access Points sends only one copy of a packet that matches a
filter to the observer. After the first match, the UNIVERGE WL Access Points
sends the packet and stops comparing the packet against other filters for the same
observer.
If the filter does not have an observer, the UNIVERGE WL Access Points still
maintains a counter of the number of packets that match the filter. (See show
snoop stats on page 622.)
Examples The following command maps snoop filter snoop1 to radio 2 on
UNIVERGE WL Access Points 3:
PROPMT# set snoop map snoop1 ap 3 radio 2
success: change accepted.
See Also
l clear snoop map on page 614
l set snoop on page 616
l set snoop mode on page 619
l show snoop map on page 621
l show snoop stats on page 622
set snoop mode
Enables a snoop filter. A snoop filter does not take effect until you map it to a
UNIVERGE WL Access Point radio and enable the filter.
Examples set snoop {filter-name | all} mode {enable | disable}
Defaults Snoop filters are disabled by default.
filter-name | all Name of the snoop filter. Specify all to enable all
snoop filters.
enable Enables the snoop filter.
disable Disables the snoop filter.