Specifications

set log
Chapter 23
System Log Commands
626
Examples To stop sending system logging messages to a server at
192.168.253.11, type the following command:
PROPMT# clear log server 192.168.253.11
success: change accepted.
Type the following command to clear all messages from the log buffer:
PROPMT# clear log buffer
success: change accepted.
See Also
l clear log trace on page 606
l set log on page 626
set log
Enables or disables logging of UNIVERGE WL Controller and AP events to the
UNIVERGE WL Controller log buffer or other logging destination and sets the
level of the events logged. For logging to a syslog server only, you can also set the
facility logged.
Syntax set log {buffer | console | current | sessions | trace}
[severity severity-level] [enable | disable]
set log server ip-addr [port port-number] severity severity-level
[local-facility facility-level]
buffer Sets log parameters for the log buffer in nonvolatile storage.
console Sets log parameters for console sessions.
current Sets log parameters for the current Telnet or console
session. These settings are not stored in nonvolatile
memory.
server ip-addr Sets log parameters for a syslog server. Specify an address
in dotted decimal notation.