Specifications

set vlan tunnel-affinity
Chapter 6
VLAN Commands
76
The following command adds port 16 to VLAN beige and assigns tag value 86 to
the port:
PROMPT# set vlan beige port 16 tag 86
success: change accepted.
See Also
l clear vlan on page 69
l set vlan name on page 74
l show vlan config on page 86
set vlan tunnel-affinity
Changes a UNIVERGE WL Controller preferences within a mobility domain for
tunneling user traffic for a VLAN. When a user roams to a UNIVERGE WL
Controller that is not a member of the user’s VLAN, the UNIVERGE WL
Controller can forward the user traffic by tunneling to another UNIVERGE WL
Controller that is a member of the VLAN.
Syntax set vlan vlan-id tunnel-affinity num
Defaults Each VLAN on a UNIVERGE WL Controller network ports has an
affinity value of 5 by default.
Access Enabled.
Usage Increasing a UNIVERGE WL Controller affinity value increases the
preferability of the UNIVERGE WL Controller for forwarding user traffic for the
VLAN.
vlan-id VLAN name or number.
num Preference of this UNIVERGE WL Controller for
forwarding user traffic for the VLAN. You can specify a
value from 1 through 10. A higher number indicates a
greater preference.