Specifications

Synergy Nano Technical Manual, Revision -
Page 12
1.1 Company Information and Assistance
Congratulations on purchasing the Synergy Nano control system. The Synergy Nano and Synergy Micro
Controllers are designed by Tidal Engineering to control the next generation of new environmental test
chambers. They can be used as drop in retrofit controllers for legacy Watlow F4 and VersaTenn controllers.
The Synergy controllers are applicable to various industrial applications including refrigeration devices for
blood storage, cold chain management and other temperature and regulatory sensitive applications.
Headquartered in Randolph, New Jersey, Tidal Engineering designs and manufactures embedded hardware
and software for test & measurement and data acquisition products. Tidal also provides engineering
services, custom electronic product development and provide turnkey distributed data acquisition and control
systems.
Tidal Engineering Corporation
2 Emery Ave
Randolph, NJ 07869
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Web Site: www.tidaleng.com
Important! Please have the application version of your Synergy Controller available when contacting us.
Parts Replacement
The Synergy controller has been designed and manufactured to provide years of reliable service. In the
event a component should fail, it is recommended that only OEM approved parts be used as replacements.
A list of replacement parts appears at the end of this manual. Please contact the Tidal Engineering for
component replacement, or repair.
Notice to Users
TIDAL ENGINEERING PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL
COMPONENTS IN LIFE-SUPPORT DEVICES OR SYSTEMS UNLESS A SPECIFIC WRITTEN
AGREEMENT REGARDING SUCH USE IS OBTAINED FROM TIDAL ENGINEERING PRIOR
TO USE.
Life-support devices or systems are devices or systems intended for surgical implantation into
the body or to sustain life, and whose failure to perform, when properly used in accordance with
instructions for use provided in the labeling and user’s manual, can be reasonably expected to
result in significant injury.
No complex software or hardware system is perfect. Bugs are always present in a system of any
size. In order to prevent danger to life or property, it is the responsibility of the system designer
to incorporate redundant protective mechanisms appropriate to the risk involved.
All Tidal Engineering products are 100 percent functionally tested. Additional testing may include visual
inspections. Specifications are based on characterization of tested sample units rather than testing over
temperature and voltage of each unit. Additional testing or burn-in of a system is available by special order.
Tidal Engineering reserves the right to make changes and improvements to its products without providing
notice.
TIDAL ENGINEERING IS A REGISTERED TRADEMARK OF TIDAL ENGINEERING CORPORATION