Specifications

Synergy Nano Technical Manual, Revision -
Page 159
Step 3. Configure the Controller
When the chamber restarts, the controller may indicate that the current chamber type differs
from the last chamber type. Press OK to acknowledge the message. You will then be asked if
you would like to discard the old settings and load the current settings. Answer YES here as
well
Then Go to the Setup Screen and open
the Chamber Setup Folder. Press
Change and select the Chamber Option
from the list.
Then press Accept
Next, Reset the Controller or Cycle power. When the chamber restarts, the controller will
indicate that the current chamber type differs from the last chamber type. This is OK. Press
OK to acknowledge that message. You will then be asked if you would like to discard the old
settings and load the current settings. Press YES on this window