Specifications

Synergy Nano Technical Manual, Revision -
Page 177
TCP/IP
To communicate over TCP/IP, connect your PC to your LAN. You must also connect your chamber to your
LAN. The Synergy Nano either requires a DHCP router to dynamically assign it an IP address or your
network administrator can assign you an available Static IP Address.
Once assigned the IP Address will appear in the
Ethernet folder of the Synergy Nano.
Note: The numbers shown are examples only.
Set SimpleComm’s IP Address to the address
displayed on the Synergy Nano. The port for the
chamber is 5000; always set SimpleComm’s port to
5000.
To enable the TCP/IP communications on the
chamber, go to the TCP/IP Server folder and set it
to Enabled.
Once the settings are complete, press SimpleComm’s Connect button. Upon successful connections the
status label will read “Socket Connected”.
Sending and Receiving Commands
To send individual commands using the SimpleComm utility, first confirm that you are connected, next type
the command into the Command text box, then either hit Enter or press the Send button. The reply from the
chamber will be displayed in the Response text box. All query commands are preceded with a “?” and all set
commands are preceded with an “=”.