Specifications

Synergy Nano Technical Manual, Revision -
Page 192
FEATURE MATRIX KEY
R Parameter is Read Only
R/W Parameter can be both Read and Write
Yes Feature is available for this controller
NA Feature is not available for this controller, or controller does not support it.
Italics * Feature is not available in ‘Monitor Only Mode’, feature has no control, is Read only or disabled.
Note: The features listed are valid for Synergy Manager Version 1.25.x.
8.3.3 Ethernet MAC Address
If your network employs a DHCP server you may find that your chamber has been assigned a different IP
Address when the DHCP server IP lease expires. Your network administrator can assign a specific and
persistent IP Address to your chamber if he has the Synergy Nano’s MAC Address, an identification number
that uniquely identifies your controller. You can determine the Synergy Nano’s MAC address using the “arp”
command in the Command widow on any PC that is on the same network as the controller.
To use the “arp” command follow these steps:
1. Connect your Synergy Nano unit to your network and apply power.
2. Determine the IP address of the Synergy Nano unit by pressing the COMM button and navigate to
the Ethernet folder. The IP Address property is displayed. Note the IP Address.
3. Open a Command window on the desktop by going to the Start button on the lower left of the
desktop and select Run from the menu.
4. Enter the letters “cmd” in the open window. Then press OK.
5. Verify the network connection to the Synergy Nano by typing “ping ###.###.###.###” where the #
signs represent the Synergy Nano unit’s IP Address.
6. In the Command window type “arp –a ###.###.###.###”, again replacing the # signs with the
Synergy Nano’s IP Address.
7. The “arp” command will respond with the Internet Address and the Physical Address (MAC Address)
of the Synergy Nano unit. The MAC address of the unit tested for this manual is 00-E0-4C-80-28-97
as shown below.