Specifications

Synergy Nano Technical Manual, Revision -
Page 194
Connecting the Synergy Nano to Your Network
Plug a network patch cable into your Synergy Nano and the other end into your hub or router. Make sure it
is powered on then boot your Synergy Nano. If your Synergy Nano is set to DHCP it should be assigned an
address automatically.
Verify DHCP IP Addressing
To confirm that the Synergy Nano was assigned an
address, press the COMM button on the controller
touch screen and select the Ethernet folder icon.
You should see a screen similar to the one below.
Verify that each field contains non-zero numbers.
The address in the Ethernet Address field is the IP
Address of the controller. Use this address when
connecting to the Synergy Nano over Ethernet.
If the addresses are blank or 0.0.0.0 then the Synergy Nano did not obtain an IP address from the DHCP
router. If this is the case, review the previous sections to make sure you have set up the DHCP router
properly. If that doesn’t solve the problem, verify the settings with your network administrator.
Synergy Nano TCP/IP Server Setup
To set up the Synergy Nano for ASCII commands
over TCP/IP, press the COMM button at the bottom
of the Synergy Nano’s touch screen. The Comm
Screen window will appear.
Select the TCP/IP Server folder icon.