Specifications

Synergy Nano Technical Manual, Revision -
Page 218
11.0 EVENTS SCREEN
EVENTS SCREEN
 Event Outputs  UUT Temperatures  Digital Outputs  Digital Inputs
(Screen Editor) (Screen Editor) (Screen Editor) (Screen Editor)
When the Synergy Nano is
in Manual operation mode,
the following outputs can
be controlled (turned On
and Off) from this screen.
♦ Event 1 thru 6
♦ Use Drier
♦ LEV2
♦ Output 11 mode
In Program mode, these
outputs are under control
of the program and can’t
be adjusted manually; they
are updated in real-time
according to the running
profile.
In the Program mode, the
status of these outputs can
be monitored. The LED is
Red when active/On.
Output 11 TPM (Time
Proportioned Mode) can
also be monitored however
this output is controlled
from the Setup screen in
Manual mode.
Status Screen
For UUT Temperature
monitoring, UUT 1 thru
UUT 8, this screen shows
actual temperature
readings of Sensors 1 thru
8 for each UUT module.
Select UUT 1 thru UUT 8
with Next or Previous
buttons.
Status Screen
The Synergy Nano’s 32
Digital Outputs are listed
on this Digital Outputs
screen. Each output in use
for the configuration is
named and the associated
LED indicates its status.
Additional information
concerning each output is
displayed in the text box at
the bottom of the screen
when the output is
selected. The text box
displays the output
designation numbers(s)
and the status of the
output.
Status Screen
LEDs show status of the
16 Digital Inputs.
Note: Input 9 is the
TempGard input.
Events Directory
The Events Directory displays the subfolders for the
six Event status screens including the event output
control screen.
♦ Events Outputs
♦ UUT Temperatures
♦ Digital Outputs
♦ Digital Inputs
♦ High Resolution Analog Inputs
♦ Low Resolution Analog Inputs