Specifications

Synergy Nano Technical Manual, Revision -
Page 224
Information on the Selected Output is displayed in the text box at the bottom of the screen. Highlight an item
(Fan, HiAl, PIDH…) by pressing the associated label. The Selected Output displayed above reads: “1: B12a,
Out 1, On/Off, On”
The output information is displayed in the following format: “A1 : A2, A3, A4, A5”
Where:
♦ A1: The location of the output as displayed on the screen 1-31 moving up to down, left to right.
♦ A2: The output board the device is connected to. The boards are referred to as 12a for the 12 output
board, 6a and 6b for sequential 6 output boards. The terms 12a, 6a, 6b correspond to the traditional
method of labeling these boards 1SM, 2SM and 3SM, respectively.
♦ A3: The output the highlighted device uses on the board specified above.
♦ A4: The output type, such as On/Off or Time Proportioning.
♦ A5: The current state of the output: On, Off or percent output (for example: 22%)
Chamber Output Mapping
The Synergy Nano supports multiple chambers types. Each chamber type has unique device output
mappings. For example, Output 1 drives the chamber fan device on Temp-Humidity and Temp-Only
chambers, but in Temp-Temp chambers Output 10 drives the fan device.
The output maps for each chamber type are listed in Section 6.9 Setup: Chamber Setup
.
Device Primitives and Logic Flow
The following flow charts illustrate the function of each output and the logic that drives each output device.
Please note that some chambers may not have all the described devices. For example, Temp-Only
chambers will not have humidity related devices such as the Wick Pan. These flow charts have extensive
references to L-Values. For more information on L-Values, see Section 6.5 Setup: L-Values
.