Specifications

Synergy Nano Technical Manual, Revision -
Page 232
TC1 – TC10 THERMOCOUPLE
CONNECTION TABLE
SENSOR + Term. - Term.
TC1 P2 - 5 P2 - 6
TC2 P2 - 7 P2 - 8
TC3 P2 - 9 P2 - 10
TC4 P2 - 11 P2 - 12
TC5 P3 - 1 P3 - 2
TC6 P3 - 3 P3 - 4
TC7 P3 - 5 P3 - 6
TC8 P3 - 7 P3 - 8
TC9 P3 - 9 P3 - 10
TC10 P3 - 11 P3 - 12
TC11 - TC16
THERMOCOUPLE
CONNECTION TABLE
SENSOR + Term. - Term.
TC11 P4 - 1 P4 - 2
TC12 P4 - 3 P4 - 4
TC13 P4 - 5 P4 - 6
TC14 P4 - 7 P4 - 8
TC15 P4 - 9 P4 - 10
TC16 P4 - 11 P4 - 12
RS – 485 COMM.
CONNECTION TABLE -
P6 CONNECTOR
DESIGNATION TERMINAL
COMM RX - P6 - 1
COMM TX + P6 - 2
COMM TX - P6 - 3
NO CONN. P6 - 4
GND. P6 - 5
NO CONN. P6 - 6
NO CONN. P6 - 7
POWER P6 - 8
COMM RX + P6 - 9
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10
Address
Switch
P1
P3
P2
P4
LED
P6
M1
M2
M3
M4
UUT MODULE - Board and Connector Layout
RS - 485 Connection
at Rear of Chamber
9 Conductor Flat
Ribbon Cable -
14 Ft. Total
Length
MODULE NO. 1
10 Ft. of Cable From First Connector To
Set of Four That Plug Into UUT Modules
M1 - M4: 9 Pin Male
Connectors for Module No. 1
thru Module No. 4,
12 Inches of cable between
each M1 - M4 connector
GND
V +
110 V Transforming
Plug Assembly
Notes:
1. One 9 conductor cable can be used
for up to 4 modules (64 T/C Inputs).
2. Power if fed from board to board via
the 9 conductor cable. Only one
power supply is needed for up to 4
modules.
3. In some instances, module power
may be obtained from the Olympic
Board Connector P9 - 1 (Gnd), and P9
- 2 (V+).
ON = Data
Comm. OK