Specifications

Synergy Nano Technical Manual, Revision -
Page 252
16.4 Installation
Installing the barcode scanner is straightforward.
Connecting the Barcode Scanner
1. Connect the USB cable to the handle of the ImageTeam 4800 and screw on the retainer clip.
2. Connect the USB connector to the Synergy Nano. .
For Synergy Nano the ImageTeam bar code scanner USB interface is used.
Once the barcode scanner is connected, continue configuring the barcode scanner as follows.
Configuring the Barcode scanner
Follow the steps below to configure the ImageTeam 4800 for use with the Synergy Nano and OCR-A fonts.
If a different configuration or barcode scanner is used, see Application note 4 for alternative settings for other
devices.