Specifications

Synergy Nano Technical Manual, Revision -
Page 253
1. First, the barcode scanner should be reset to factory defaults. The subsequent steps adjust only those
settings that differ from the factory defaults. Scan the barcode below to reset.
2. Scan the “Control + ASCII Mode On” symbol. To Enable Control + ASCII mode on the barcode.
3. Scan the following.
4. Enable the CTRL+F Prefix. This is sent before the scanner sends the barcode data.
a. Scan the “Add Prefix” symbol.
b. Scan the “9” symbol.
c. Scan the “9” symbol.
d. Scan the “0” symbol.
e. Scan the “6” symbol.
f. Scan the “Save” symbol.